What problems will be encountered in the opening of plush toys

Plush toys before the order production, will print out the sample to confirm the product, then in the process of making a model, there will be many problems, in this process how to improve the product is very important, the following plush toys custom manufacturers popular science under the general open version of the problem.

First, when customers need to customize plush toys, they need to send the design drawings to the designer. The designer will analyze the design draft, and then distinguish the material and process method corresponding to the template according to the requirements. Normally, there are two modes of 3D model publishing and manual publishing. Generally, the material used for making the sample plate: 200 cardboard for the original sample and 0.8 mm elastic paper for the production sample. The sample paper should be flat, clean and dry.

Second, in the process of plush toy proofing, attention must be paid to the production principles of straight line, arc, angle, proportion, symmetry and positioning of the sample, and the text description should be written on the front of the sample.

Third, if you want to produce, you need to copy the original version. You must pay attention to the accuracy of the copy and keep consistent with the original template. If the sample length is less than 10cm, there should be no error; if it is more than 10cm, the error is allowed to be within 0.5cm. In order to maintain the accuracy of the template and check the deformation degree of the template, it is necessary to repeatedly check with the original template in the process of use. In case of any non conformity, it shall be replaced in time. When the fabric is cut, it is necessary to enlarge or reduce the sample plate when the material or process of the fabric is different, but this can only be determined after the sample is sealed and confirmed.

Fourth, in order to identify the template correctly, the logo of the template is very important. The mark of the sample includes: product model, product name, part name and sample number, material name (processing requirements). All the contents mentioned above must be marked on the sample plate.

Fifthly, the layout diagram is to indicate the arrangement of each template with minimum material consumption. The layout diagram will generally show the general information of the pattern wire flow or hairiness direction, pattern plate reverse arrangement or in the same direction, and template nesting. This can better control the cost.